UNIT INFORMATION

Disclaimer

This unit information may be updated and amended immediately prior to semester. To ensure you have the correct outline, please check it again at the beginning of semester.

ENM1102 Engineering Drawing and Computer Aided Design
SCHOOL OF ENGINEERING
Credit Points: 15
 
Description:

This unit introduces students to technical drawing and the use of two-dimensional computer-aided design tools. Students will progress from hand drawings which meet relevant Australian standards to the use of computer-aided design tools for engineering drawings. Although the emphasis is on mechanical drawings, an introduction to electrical drawings will also be provided.


This Unit is part of the following Courses / Unit Sets
E66Bachelor of Engineering (Computer Systems)
E75Bachelor of Engineering (Computer Systems)/Bachelor of Business
G98Bachelor of Engineering (Electronics and Communications)
G93Bachelor of Engineering (Instrumentation Control and Automation)
G69Bachelor of Engineering (Mechatronics)
K06Bachelor of Engineering (Mechatronics)/Bachelor of Technology (Motorsports)
U78Bachelor of Technology (Electronic and Computer Systems)
G68Bachelor of Technology (Motorsports)
MAAACCInstrumentation Control and Automation Major
MAAACAMechatronics Major
 
 
Disability Standards for Education (Commonwealth 2005)
For the purposes of considering a request for Reasonable Adjustments under the Disability Standards for Education (Commonwealth 2005), inherent requirements for this subject are articulated in the Unit Description, Learning Outcomes, Graduate Attributes and Assessment Requirements of this entry. The University is dedicated to provide support to those with special requirements. Further details on the support for students with disabilities or medical conditions can be found at the Student Equity, Diversity and Disability Service website:
http://intranet.ecu.edu.au/student/support/student-equity

Last Updated - Higher Education: 31/03/2008 VET: 31/03/2008