UNIT INFORMATION
Disclaimer
This unit information may be updated and amended immediately prior to semester. To ensure you have the correct outline, please check it again at the beginning of semester.
ENM1102 | Engineering Drawing and Computer Aided Design | ||
SCHOOL OF ENGINEERING | |||
Credit Points: 15 | |||
Description: | |||
This unit introduces students to technical drawing and the use of two-dimensional computer-aided design tools. Students will progress from hand drawings which meet relevant Australian standards to the use of computer-aided design tools for engineering drawings. Although the emphasis is on mechanical drawings, an introduction to electrical drawings will also be provided. | |||
This Unit is part of the following Courses / Unit Sets | |||
G69 | Bachelor of Engineering (Mechatronics) | ||
G68 | Bachelor of Technology (Motorsports) | ||
Disability Standards for Education (Commonwealth 2005) | |||
For the purposes of considering a request for Reasonable Adjustments under the Disability Standards for Education (Commonwealth 2005), inherent requirements for this subject are articulated in the Unit Description, Learning Outcomes, Graduate Attributes and Assessment Requirements of this entry. The University is dedicated to provide support to those with special requirements. Further details on the support for students with disabilities or medical conditions can be found at the Student Equity, Diversity and Disability Service website: | |||
http://intranet.ecu.edu.au/student/support/student-equity |
Last Updated - Higher Education: 3/31/2006 VET: 3/31/2006