UNIT INFORMATION

Disclaimer

This unit information may be updated and amended immediately prior to semester. To ensure you have the correct outline, please check it again at the beginning of semester.

ENS3105 Mechanical Design and Development
SCHOOL OF ENGINEERING
Credit Points: 15
Prerequisites:
ENM1102 Engineering Drawing and Computer Aided Design
ENS1115 Materials and Manufacturing 1
 
Description:

This unit introduces the general principles of mechanical design and applies these to product development, from concept to detailed design. It considers methods for evaluation and selection of alternative designs. It then engages students in a major multidisciplinary design and development project, which may integrate elements of electrical, electronic and mechanical engineering.



Full Unit Outline

This Unit is part of the following Courses / Unit Sets
K53Bachelor of Engineering (Civil)
K52Bachelor of Engineering (Mechanical)
G69Bachelor of Engineering (Mechatronics)
K06Bachelor of Engineering (Mechatronics) Bachelor of Technology (Motorsports)
MABUSPMechanical Engineering Major
MABUSKMechatronics Major
 
 
Disability Standards for Education (Commonwealth 2005)
For the purposes of considering a request for Reasonable Adjustments under the Disability Standards for Education (Commonwealth 2005), inherent requirements for this subject are articulated in the Unit Description, Learning Outcomes, Graduate Attributes and Assessment Requirements of this entry. The University is dedicated to provide support to those with special requirements. Further details on the support for students with disabilities or medical conditions can be found at the Student Equity, Diversity and Disability Service website:
http://intranet.ecu.edu.au/student/support/student-equity

Last Updated - Higher Education: 15/03/2012 VET: 15/03/2012